Thanks, I will try and come back with the results.

It may affect also other routers including the v2 Any chance to have an improvement on this? When it comes back on the wired clients do not see the network again until using the repair connection on PC. Will this only apply for the V4 or will apply for the other versions of C7? On the V2 what is annoying during boot time is that it assigns the IP, Gateway and the other network settings to the wired clients and then it goes down for a minute. I made a patch right now which reduced the boottime alot. this has been fixed right now (internally) the v4 has some performance problem with the flash memory. the internet led is orange if you're offline and is green if your wan port got dhcp or any other connection.īeside this i made a patch right now which reduced the boottime alot. The wps shows the security state and nothing else. The LEDs (WPS and Internet) doesn't show the real state (always on). Last week I bought a Archer 1750 v4 and flashed it with brand new image from dd-wrt (tplink_archer-c7-v4.bin).Īfter the first 24h the WLAN and Ethernet seams to working properly with some minor exceptions. 'So you tried to use the computer and it started smoking? Sounds like a Mac to me.' - Louis Rossmann Or you extract the uimage + filesystem from the tplink firmware and flash it using the mtd command to the linux partition there is a factory-to-ddwrt.bin which is for flashing from tplinks original firmware and there is a webflash image which is used for upgrading existing dd-wrt firmwaresįor flashing back to original firmware you may use the tftp recovery method (which doesnt seem to work for me unfortunatly) Start here: Īnd in there you'll see both the (I think) newest dd-wrt build and the original image. I'd link you directly to the file if I could.

Foxfi android 6 drops after 30 minutes